Station Name Assignment - NEC Xen IPK Programming Manual

Xen IPK

Station Name Assignment

General Description
Use this Memory Block to assign names for telephone stations.
Display
Tel Port
No.
Data
(01~99)
No.
A0~C0
0 1 / 1 8 : <
T I M E
Programming Procedures
1 Go off-line.
2 Press LK4 + A H
3 Use the dial pad to enter data. Refer to Section 7, Character Code Tables, and
enter the 3-digit code to display each character.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
U
to clear all data when cursor is at setting data position
R
to go to next Tel Port No.
N
4 Press to write the data.
5 After entering all data, press
P
6 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. While an internal line is ringing or in use, the station number and name of the other party are displayed.
2. The name is not displayed when Tone Override, Automatic Callback, or Callback Request is displayed
3. Only 6 digits/characters can be used for each name.
4. Telephone ports A0~C0 are ports 100~120.
4-18, Station Name Assignment
Setting
Data
>
D I S P L A Y
to access the Memory Block.
N
Programming Manual
4-18
System Mode
Submode
Data No.
PC Programming
Default Values
Not Specified
DRAFT 3
Chapter 1 – 425
4
—
18
+ BTT