NEC Xen IPK Programming Manual page 187

Xen IPK
Programming Procedures
3 Use the dial pad to enter the time required.
Note: J to move cursor left.
L to move cursor right.
Setting Data (Allow): 01 to 99 sec
N
4 Press to write the data.
P
Press to go back on-line.
5
Related Programming
M.B. Number
4-71 Time Class Assignment for Telephone Mode (R2000 and above)
N
After PBR is connected, dialling must be completed in the specified time. After the first digit is dialled, interdigit timing
(default 7 sec.) controls the PBR timer. Dialling the third digit exceeds the 20 sec. default, and the PBR is disconnected.
1-4-01, Automated Attendant First Digit PBR Release Timer Selection
Default values: 20 secs
Memory Block Name
Programming Manual
DRAFT 3
Chapter 1 – 167