NEC Xen IPK Programming Manual page 343

Xen IPK
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
1-8-08 Class of Service (Station) Feature Selection 2 (Page 6, LK 2)
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
1-15-11 Centralised Billing Allow/Deny Selection
1-15-12 Centralised Billing – Point Code of Center Office Assignment
1-15-13 Centralised Day/Night Switching for Remote Office Assignment
1-15-14 Centralised Day/Night Switching for Main Office Assignment
1-15-15 Centralised BLF Send Extension Number Assignment
1-15-17 Centralised BLF Send Time Assignment
1-15-18 Centralised BLF Display Extension Number Assignment
3-70 CIC Number Assignment
4-12 Line Key Selection for Telephone Mode
4-17 Station to Class of Service Feature Assignment
5-05 Common Signalling Channel Route Assignment
N
1. The Send Group Number selected by the Line Key is the Group number assigned in Memory Block 1-15-15
(Centralised BLF Send Point Code Assignment).
2. Up to 120 Extension Numbers (entries in the table) can be assigned to send BLF messages. With each assigned
extension number, up to eight destination offices can be selected until 240 extension numbers are assigned.
3. A maximum of 240 total sending Extension Numbers (BLF messages) can be assigned. If 30 Extension Numbers
(entries in the table) are assigned with each set for all eight groups (systems), the 240 limit is reached and no more
Extension Numbers can be entered.
4. When a Send Group (Point Code) is cleared in Memory Block 1-15-15, it is also cleared in this Memory Block.
1-15-16, Centralised BLF Send Extension Number Assignment
Memory Block Name
Programming Manual
DRAFT 3
Chapter 1 – 323