Customised Message 1~10 Assignment - NEC Xen IPK Programming Manual

December 2004
Customised Message 1~10
Assignment
General Description
Use this Memory Block to program various messages for display at a station LCD. When a user
places an intercom (ICM) call from a station equipped with an LCD display to a station in DND
mode, the appropriate programmed message displays at the calling station.
Display
Data
No.
0 9 : D O N ' T D I S T U R B
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 + KI
3
Enter the options using the dial pad.
Note: Use the following enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
U
to clear data
4 Enter the characters to be displayed. Refer to Section 7, Character Code Tables.
After entering all data for Memory Block , 1-2-09~18 , Customised Message 1~10 Assignment, press
5
data.
P
6 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Ten messages are available, the first six are assigned at default.
2. Ten messages are available, the first six are assigned at default.
3. System Software allows a message to be entered using the dial pad instead of the ASCII Character Code Tables.
Follow the procedure in Appendix B Character Codes, Section 1 Character Assignment on page B-1.
DRAFT 3
136 – Chapter 1
Setting Data
(13 Digits max.)
D I S P L A Y
~
AH to access the Memory Block.
Default Values
Data No. Message
09 DON'T DISTURB
10 MEETING
11 BUSINESS TRIP
12
13 WITH GUEST
14 OUT OF OFFICE
~
Not Specified
15 18

Customised Message 1~10 Assignment, 1-2-09~18

NEC Business Solutions Ltd
1-2-09~18
System Mode
1
Submode
2
Data No.
09~18
PC Programming
+BI
NOT IN
N
to write the