K-Ccis Main/Remote Office Selection - NEC Xen IPK Programming Manual

Xen IPK
K-CCIS Main/Remote Office
Selection
General Description
Use this Memory Block to activate
Applicable for IPK R2000 and above.
Display
Data
Title
No.
0 0 : C C I S
T I M E
Settings
LK1 LK2
NONE MAIN REMOTE
Programming Procedures
1 Go off-line.
Press LK1 + LK15 to access the Memory Block.
2
3 Press the corresponding CO/PBX line key to change the Setting Data option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
1-15-11 Centralised Billing Allow/Deny Selection
1-15-12 Centralised Billing – Point Code of Center Office Assignment

1-15-00, K-CCIS Main/Remote Office Selection

CCIS by assigning a Main or Remote system
K-
Setting
Data
N O N E
D I S P L A Y
LK3 LK4 LK5
.
LK6 LK7
Memory Block Name
Programming Manual
System Mode
1
Submode
15
Data No.
00
PC Programming
+ AW
LK8
The shaded area indicates
the default setting.
DRAFT 3
Chapter 1 – 291
1-15-00