NEC Xen IPK Programming Manual page 426

December 2004
Settings
Page 7 (Ports 49~56)
LK 1 LK 2
49 50
LK 5 LK 6
53 54
Page 8 (Ports57~64)
LK 1 LK 2
57 58
LK 5 LK 6
61 62
Programming Procedures
1 Go off-line.
KA
2 Press LK4 +
Press the CO/PBX Line key corresponding to each CO/PBX number.
3
The LED indication changes to indicate data each time a CO/PBX line key is
pressed.
CO/PBX
Line Key LED
Data
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
R
to move to the next Tel No.
S
to move to the next page
T
to move to the previous page
4 After entering all data for all pages, press
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Telephone ports A0~C0 are ports 100~120.
DRAFT 3
406 – Chapter 1
LK 3
51
LK 7
55
LK 3
59
LK 7
63
to access the Memory Block.
Off Green
Immediate
No ring
Ring
N
to write the data.
LK 4
52
LK 8
56
LK 4
60
LK 8
64
Red
Delayed
Ring
CO/PBX Ring Assignment (Day Mode), 4-01
NEC Business Solutions Ltd
Default Values
Tel Port numbers 01 and 02 ring on
~
CO/PBX lines 01 08.
~
Tel Port numbers 03 120 do not ring
on any incoming CO/PBX calls.