No Response From Right Siacm - Chrysler Concorde 2004 Service Manual

Symptom:

*NO RESPONSE FROM RIGHT SIACM

INTERROGATE ACM
GROUND CIRCUIT OPEN
FUSED IGNITION SWITCH OUTPUT RUN/START CIRCUIT OPEN
RIGHT SIDE IMPACT AIRBAG CONTROL MODULE
PCI BUS CIRCUIT OPEN
BODY CONTROL MODULE
TEST
1 Note: Ensure the battery is fully charged.
Turn the ignition on.
With the DRBIII , select Passive Restraints.
With the DRBIII , select Airbag and read the active DTC's.
Is the Loss Of Ignition Run/Start DTC set?
Yes → Refer to the symptom list and perform the Loss Of Ignition
→ Go To 2
No
2 Ensure that the battery is fully charged.
Warning: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Right Side Impact Airbag Control Module harness connector.
Connect the appropriate Load Tool SIACM Adapter to the SIACM connector.
Using a 12-volt test light connected to 12-volts, probe the ground circuit.
NOTE: Make sure test light is connected to the Battery positive terminal.
Is the test light illuminated?
Yes → Go To 3
→ Repair the Ground circuit for an open.
No
Note: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
POSSIBLE CAUSES
ACTION
Run/Start symptom.
Perform AIRBAG VERIFICATION TEST - VER 1.
Perform AIRBAG VERIFICATION TEST - VER 1.
167
COMMUNICATION
APPLICABILITY
All
All