Rear Axle Location Index; General Procedures; Precaution (Front And Rear Axle - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

REAR AXLE LOCATION INDEX

Wheel hub, hub spindle

M–9 WHEEL HUB, HUB SPINDLE PRE-

M–10 WHEEL HUB, HUB SPINDLE

REMOVAL/INSTALLATION)

Wheel and Tire Removal/Installation

1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a

wheel is removed, tighten it to 88—118 N·m {9.0—12.0 kgf·m, 65.0—87.0 ft·lbf}

Brake Line Disconnection/Connection

• Brake fluid will damage painted surfaces. If brake fluid gets on a painted surface, wipe it off

immediately.

1. Tighten the brake pipe flare nut using the SST (49 0259 770B). Be sure to modify the brake pipe flare nut

tightening torque to allow for use of a torque wrench-SST combination. (See

2. If any brake line has been disconnected any time during the procedure, add brake fluid, bleed the brakes, and

inspect for leakage after the procedure has been completed.

Suspension Arm Removal/Installation

1. Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered and

• Unloaded: Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack, and tools

are in designated position.

LOCATION INDEX, GENERAL PROCEDURES

A6E630005000W01

A6E631001018W01

GI–16 TORQUE

Table of Contents