3. Disconnect the cord assembly connector.
4. Verify that there is no continuity between cord
assembly terminal and ground.
• If as continuity, inspect the cord assembly.
• If the cord assembly is okay, inspect the oil
pressure switch. (See
Inspection (oil pressure switch
5. Connect the cord assembly connector.
6. Install the under cover.
7. Connect the negative battery cable.
On-vehicle Inspection (oil pressure switch inspection)
1. Remove the under cover.
2. Disconnect the cord assembly connector.
3. Start the engine, with gear position in N or P.
4. Reaffirm that there is no continuity between cord
assembly terminal and ground.
5. Firmly depress the brake pedal with the left foot.
6. Shift the selector lever to D range.
7. Verify that there is no continuity between cord
assembly terminal and ground.
• If not as specified,replace the oil pressure
switch. (See
K–23 OIL PRESSURE SWITCH
REMOVAL/INSTALLATION.)
8. Connect the oil pressure switch connector.
9. Install the under cover.
10. Connect the negative battery cable.
K–22
AUTOMATIC TRANSAXLE
K–22 On-vehicle
inspection).)
A6E5614W026
A6E5614W027
A6E5614W026
A6E5614W094