Rear Beltline Molding Removal; Rear Beltline Molding Installation - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

REAR BELTLINE MOLDING REMOVAL

• When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with

1. Pull the A section upward and remove the clip.

2. Rotate the B section of the front beltline molding

in direction (2), along the direction (1) shown in

the figure and remove it from the body.

3. Pull the C section upward and remove the clip.

Then remove the front beltline molding.

1. Press the clip at the C section into the body.

2. Press in the B section of the rear beltline molding

along the direction (1) to attach it to the body.

3. Press the clip at the A section in and attach the

rear beltline molding.

• If the rear beltline molding is difficult to

attach, apply soapy water.

A6E773050660W01

A6E773050660W02

Table of Contents