Emission System; Charcoal Canister Inspection; Evaporative Gas Check Valve (One-Way) Inspection (L.h.d; Purge Solenoid Valve Removal/Installation - Mazda 2002 6 Workshop Manual

CHARCOAL CANISTER INSPECTION

1. Remove the charcoal canister.
2. Plug the atmosphere side port and purge solenoid valve side port of the charcoal canister.
3. Blow air into the charcoal canister from the fuel tank side port and verify that there is no air leakage.
• If there is air leakage, replace the charcoal canister.
End Of Sie

EVAPORATIVE GAS CHECK VALVE (ONE-WAY) INSPECTION (L.H.D.)

1. Remove the evaporative gas check valve (one-way).
2. Apply pressure to port A, and verify that there is no airflow.
• If there is airflow, replace the evaporative gas check valve (one-way).
3. Apply negative pressure to port A, and verify that there is air flow.
• If there is no airflow, replace the evaporative gas check valve (one-way).
End Of Sie

PURGE SOLENOID VALVE REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
1 Evaporative hose (to charcoal canister)
(See F–38 Evaporative Hose Installation
2 Vacuum hose (to intake manifold)
(See F–38 Vacuum Hose Installation
3 Purge solenoid valve
3. Install in the reverse order of removal.
Vacuum Hose Installation Note
1. Attach the vacuum hose onto the purge solenoid valve until it contacts the stopper.
Evaporative Hose Installation Note
1. Attach the evaporative hose onto the purge solenoid valve until it contacts the stopper.
End Of Sie
F–38

EMISSION SYSTEM

EMISSION SYSTEM
Note)
Note)
A6E391613970W01
A6E3916W002
A6E391613988W01
A6E3916W001
A6E391618740W01
A6E3916W024