Pre-Tensioner Seat Belt - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

8. Control the SST (Deployment tool) to the SST

(Adapter harness).

9. Connect the red clip of the SST (Deployment tool)

to the positive battery terminal and the black clip

to the negative battery terminal.

10. Verify that the red light on the SST (Deployment

tool) is illuminated.

11. Make sure all persons are standing at least 6 m

{20 ft} from the vehicle.

12. Press the activation switch on the SST

(Deployment tool) to deploy the curtain air bag

Pre-tensioner seat belt

1. Remove the pre-tensioner seat belt. (See

• If the pre-tensioner seat belt is not properly installed to the tire, serious injury may occur when the

pre-tensioner part is deployed. When installing the pre-tensioner seat belt to the tire, make sure

the pre-tensioner part is inside the tire.

2. Connect the SST (Adapter harness) to the pre-

tensioner seat belt as shown in the figure.

3. With the pre-tensioner part inside the tire, tie the

pre-tensioner seat belt to the tire. Wrap the wire

harness through the tire and around the pre-

tensioner seat belt at least four times.

AIR BAG SYSTEM

S–100 FRONT SEAT BELT

REMOVAL/INSTALLATION.)

Table of Contents