Troubleshooting; No.1 While Vehicle Is In Reverse, Vehicle Locator Mark Goes Forward - Mazda 2002 6 Workshop Manual

CAR-NAVIGATION SYSTEM
Troubleshooting Index
• Use the chart below verify the trouble in order to diagnose the appropriate area.
No.
1 While vehicle is in reverse, vehicle locator mark goes forward.
2 In navigation mode, vehicle locator mark skips.
Even when headlight switch is turned on, daytime screen does not change to night time screen.
3
(Front and rear combination lights operate normally.)
End Of Sie

NO.1 WHILE VEHICLE IS IN REVERSE, VEHICLE LOCATOR MARK GOES FORWARD.

• When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while
doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If
there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and
undamaged.
1 While vehicle is in reverse, vehicle locator mark goes forward.
TROUBLESHOOTING HINTS
• Malfunction in shift position (R range (ATX) or revese position (MTX)) signal line of car-navigation unit.
— Car-navigation unit malfunction
— Malfunction in wiring harness between car-navigation unit and transaxle range switch
— Transaxle range switch malfunction
Diagnostic procedure
STEP
• While the vehicle is in reverse, are back-up
1
lights illuminated?
• Disconnect car-navigation unit connector
2*
(16-pin).
• Turn ignition switch to ON position.
• Shift selector lever to R range (ATX) or
revese position (MTX).
• Measure voltage at the following terminal of
car-navigation unit connector (16-pin,
harness side):
— Terminal 2L (Shift position (R range (ATX)
or revese position (MTX)) signal)
• Is voltage 9 V or more?
• Does vehicle locator mark indicate actual
3
position of vehicle?
End Of Sie
NO.2 IN NAVIGATION MODE, VEHICLE LOCATOR MARK SKIPS.
2 In navigation mode, vehicle locator mark skips.
TROUBLESHOOTING HINTS
• Malfunction in vehicle speed signal line of car-navigation unit.
— Car-navigation unit malfunction
— ABS (ABS/TCS) HU/CM malfunction (with ABS (ABS/TCS))
— DSC HU/CM malfunction (with DSC)
— Malfunction in wiring harness between car-navigation unit and instrument cluster

TROUBLESHOOTING

TROUBLESHOOTING
Malfunction symptom
INSPECTION
Yes Go to next step.
No Repair back-up light circuit, then go to next step.
Yes Replace car-navigation unit (available at Clarion service
center) or get it repaired at Panasonic Service center, then
go to next step.
No ATX
• Inspect wiring harness between car-navigation unit (16-
pin, terminal 2L) and transaxle range switch, then go to
next step.
MTX
• Inspect wiring harness between car-navigation unit (16-
pin, terminal 2L) and back-up light switch, then go to
next step.
Yes Complete troubleshooting, then explain repairs to customer.
No Recheck malfunction symptoms, then repeat from Step 1 if
malfunction recurs.
A6E818066000W01
A6E818066000W02
ACTION
A6E818066000W03
T–229
T