Mazda 2002 6 Workshop Manual page 135

Hide thumbs Also See for 2002 6:

Table of Contents

5. Engage the snap fit tab and lower case, and verify

that they are properly engaged.

6. Verify that the O-ring is seated in the upright

position without twisting.

Type A, B, C

• Be careful not to damage the O-ring. If it is damaged, sealing damage might occur causing fuel

7. Apply clean oil to the new O-ring.

• Do not pull out the fuel hose between the pressure regulator and reserve cup (2WD) or between

the pressure regulator and transfer jet pump (4WD). In addition, do not forcibly rotate or bend it, or

it may cause damage to the fuel hose sealing or pipe breakage/splitting. If the fuel hose is buckled

and fuel flow distortion occurs, it may cause jet pump performance deterioration.

8. Install a new O-ring to the pressure regulator.

• Perform Step 9 (4WD).

• Go to Step 11 (2WD).

9. Install a new O-ring to the transfer jet pump (4WD).

• After installing the fuel filter (high-pressure) to the reserve cup, install the transfer jet pump completely

10. Set the transfer jet pump to the reserve cup (4WD).

11. Verify that the reserve cup is not split, chipped, or

12. Install the fuel filter (high-pressure) to the reserve

13. Engage the snap fit tab and reserve cup, and

verify that they are properly engaged.

SNAP FIT TAB

FUEL FILTER (LOW-PRESSURE)

C6E114ZL4009

C6E114ZL4028

C6E114ZL4033

Chapters

Table of Contents