Drive Shaft (Atx) Disassembly/Assembly - Mazda 2002 6 Workshop Manual

Drive Shaft Installation Note
Caution
• The sharp edges of the drive shaft can
slice or puncture the oil seal. Be careful
when installing the drive shaft to the
transaxle.
• The oil seals are damaged easily if this
procedure is not done correctly.
1. Insert the drive shaft into the wheel hub.
2. Apply transaxle oil to the oil seal lip.
3. Push the drive shaft into the transaxle.
4. After installation, pull the transaxle side outer ring
forward to confirm that the drive shaft is securely
held by the clip.
End Of Sie

DRIVE SHAFT (ATX) DISASSEMBLY/ASSEMBLY

1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
.
1 Boot band (wheel side)
(See M–20 Boot Band (Wheel Side) Disassembly
Note)
(See M–23 Boot Band (Wheel Side) Assembly
Note)
2 Boot band (transaxle side)
(See M–20 Boot Band (Transaxle Side)
Disassembly Note)
(See M–23 Boot Band (Transaxle Side) Assembly
Note)
3 Outer ring
(See M–20 Outer Ring Disassembly
(See M–22 Outer Ring Assembly
4 Snap ring
(See M–20 Snap Ring, Tripod Joint Disassembly
Note)
(See M–22 Tripod Joint, Snap Ring Assembly
DRIVE SHAFT
5
6
7
8
Note)
Note)
9
10
Note)
Tripod joint
(See M–20 Snap Ring, Tripod Joint Disassembly
Note)
(See M–22 Tripod Joint, Snap Ring Assembly
Free ring
Boot
(See M–21 Boot Disassembly
(See M–22 Boot Assembly Note)
ABS sensor rotor (with ABS)
(See M–21 ABS Sensor Rotor (With ABS)
Disassembly Note)
(See M–22 ABS Sensor Rotor (With ABS) Assembly
Note)
Shaft and ball joint component
Dynamic damper
(See M–21 Dynamic Damper Assembly
A6E6316W003
A6E631625500W03
M
A6E0313W043
Note)
Note)
Note)
M–19