Rear Bumper Removal/Installation - Mazda 2002 6 Workshop Manual

REAR BUMPER REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the rear combination light.
3. Remove in the order indicated in the table.
1 Screw A
2 Screw B
3 Screw C
4 Fastener A
5 Bolt A
6 Fastener B
7 Rear bumper
(See S–49 Rear Bumper Removal
(See S–49 Rear Bumper Installation
8 Refractor
(See S–50 Refractor Removal
9 Bolt B
10 Rear bumper reinforcement
4. Install in the reverse order of removal.
Rear Bumper Removal Note
1. Pull the rear bumper ends (wheel arch) outward
to disengage with the bumper slider.
Caution
• If only one side of the rear bumper is
disengaged from the bumper slider and
the bumper falls, it could be damaged.
When disengaging the rear bumper from
the slider, secure the bumper so that it
does not fall.
Rear Bumper Installation Note
1. Spread the rear bumper ends (wheel arches) apart.
2. Attach the rear bumper to the body.
3. Press the rear bumper connection portion into the body to engage with the bumper slider.
BUMPER
Note)
Note)
Note)
A6E772650221W01
A6E7726W001
S
A6E7726W007
S–49