Glass Panel Adjustment; Front Drain Hose Removal; Front Drain Hose Installation - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

GLASS PANEL ADJUSTMENT

1. Fully close the glass panel.

2. Measure the gap and height between the glass panel and body.

3. If not as specified, loosen the glass panel installation screws and reposition the glass panel.

a: -0.8—1.2 mm {-0.032—0.047 in}

b: 0 mm {0 in}

4. Tighten the installation screws.

5. Insert a prepaid card between the weatherstrip

and the body of the vehicle. Verify that the sunroof

is shut tightly (there is resistance when the

prepaid card is moved).

• If the sunroof is not shut tightly, readjust by

performing Steps 3 and 4.

1. Remove the headliner.

2. Disconnect the front drain hose from the sunroof frame.

3. Remove the front drain hose from the clips.

4. Pull the front drain hose into the room side.

5. Remove the front drain hose.

• If the front drain hose is pinched or bent anywhere, the water in the hose may not discharge and

enter the inside of the vehicle. During and after installation of the trims and the headliner, always

make sure there is no interference with the front drain hose. Fix any problem if found.

1. Apply soapy water to the front drain hose inserting area.

2. Insert one end (the wider end) of the front drain hose into the sunroof frame.

3. Install the front drain hose to the clips, parallel to the pillar and free of slack.

4. Insert the front drain hose joint into the hinge pillar inner hole.

5. Install the headliner.

SLIDING SUNROOF

A6E774069810W02

A6E774069920W01

A6E774069920W02

Table of Contents