Steering Angle Sensor Inspection; Light Switch Removal/Installation - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

STEERING ANGLE SENSOR INSPECTION

1. Remove the column cover. (See

2. Disconnect the steering angle sensor connector.

3. Connect battery positive voltage to terminal A and ground to terminal F of the steering angle sensor.

4. Turn the steering wheel to the right and left, and

verify that the voltage and pulses at the terminals

are as shown in the figure.

• If not as specified, replace the body of the

combination switch.

1. Disconnect the negative battery cable.

2. Remove the column cover. (See

3. Remove in the order indicated in the table.

Light switch

4. Install in the reverse order of removal.

EXTERIOR LIGHTING SYSTEM

S–84 COLUMN COVER

REMOVAL/INSTALLATION)

A6E811266120W03

A6E811266121W01

Table of Contents