Cylinder Head Gasket; Cylinder Head Gasket Replacement - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

3. Tighten the bolts in the order shown.

Tightening torque:

8.0—11.5 N·m {81.6—122.3 kgf·cm, 70.9—

106.2 in·lbf}

• Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep

sparks and flames away from fuel.

• Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and

damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line

Safety Procedure". (See

1. Remove the timing chain. (See

2. Remove the ignition coil. (See

3. Remove the high-tension lead. (See

4. Disconnect the generator, but do not remove it from the vehicle. After disconnection, fix the generator using a

rope to prevent it from falling. (See

5. Remove the front pipe. (See

6. Remove the intake manifold. (See

7. Disconnect the heater hose, bypass hose, radiator hose.

8. To firmly support the engine, first set the engine

jack and attachment to the oil pan.

9. Remove in the order indicated in the table.

10. Install in the reverse order of removal.

11. Inspect the compression. (See

INSPECTION.)

TIMING CHAIN, CYLINDER HEAD GASKET

CYLINDER HEAD GASKET

F–17 Fuel Line Safety

B–10 TIMING CHAIN

G–8 IGNITION COIL

G–10–1 HIGH-TENSION LEAD

G–6 GENERATOR

F–35 EXHAUST SYSTEM

F–10 INTAKE-AIR SYSTEM

REMOVAL/INSTALLATION.)

A6E221810271W01

Table of Contents