Rear Brake (Disc) Inspection - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

Bleeder Screw Assembly Note

1. Assemble the bleeder screw to the caliper using

Tightening torque

6.9—9.8 N·m {71—99 kgf·cm, 62—86 in·lbf}

REAR BRAKE (DISC) INSPECTION

Brake Judder Repair Hint

P–17 FRONT BRAKE (DISC)

Disc Plate Thickness Inspection

• Excessive runout may result if the disc plate is removed from the vehicle then machined. Machine

the disc plate while installed on the vehicle.

1. Measure the thickness of the disc plate.

• If the thickness is not within the specification, replace the disc plate.

8 mm {0.31 in}

Minimum thickness after machining using a brake lathe on-vehicle

8.8 mm {0.35 in}

Disc Pad Thickness Inspection

1. Jack up the front of the vehicle and support it with safety stands.

2. Remove the wheel and tires.

3. Verify the remaining thickness of the pads.

Minimum thickness

2.0 mm {0.079 in} min.

4. Replace the pads as a set: right and left wheels, if

either one is at or less than the minimum

CONVENTIONAL BRAKE SYSTEM

INSPECTION.)

A6E691226980W01

Table of Contents