Front Door Trim Removal/Installation; Rear Door Trim Removal/Installation - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

FRONT DOOR TRIM REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Open the cap using a small screwdriver, then

remove the screw.

3. Remove the inner handle cover.

4. Remove the inner garnish.

5. Remove the cover, then remove screw A.

6. Remove the lens cover, then remove screw B.

7. Disengage clips A from the front door using a

fastener remover.

8. Pull the front door trim upward, then disengage

hooks B from the front door.

9. Disconnect the power door mirror switch

connector and the power window main switch

connector (driver's side) or power window

subswitch connector (passenger's side).

10. Remove the courtesy light.

11. Remove the front door trim.

12. Remove the switch panel from the front door trim.

13. Install in the reverse order of removal.

1. Disconnect the negative battery cable if equipped with power window system.

2. Remove the regulator handle if equipped.

3. Open the cap using a small screwdriver, then

remove the screw.

4. Remove the inner handle cover.

5. Remove the cover, then remove screw.

6. Disengage clips A from the rear door using a

fastener remover.

A6E774468420W01

A6E774468520W01

Table of Contents