Fuse Block Removal/Installation; Ignition Switch Removal/Installation; Ignition Switch Inspection - Mazda 2002 6 Workshop Manual

FUSE BLOCK REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the left-side front side trim. (See
3. Remove in the order indicated in the table.
1 Connector
2 Bolt
3 Fuse block
4. Install in the reverse order of removal.
End Of Sie

IGNITION SWITCH REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the column cover. (See
3. Remove in the order indicated in the table.
1 Connector
2 Screw
3 Ignition switch
4. Install in the reverse order of removal.
End Of Sie

IGNITION SWITCH INSPECTION

1. Disconnect the negative battery cable.
2. Remove the column cover. (See
3. Disconnect the ignition switch connectors.
4. Inspect for continuity between the ignition switch
terminals using an ohmmeter.
• If not as specified, replace the ignition switch.
End Of Sie
T–20
POWER SYSTEM
S–88 FRONT SIDE TRIM
S–84 COLUMN COVER
S–84 COLUMN COVER
A6E8110W114
REMOVAL/INSTALLATION)
REMOVAL/INSTALLATION)
REMOVAL/INSTALLATION)
A6E811066730W01
A6E8110W107
A6E811066151W01
A6E8110W101
A6E811066151W02
A6E8110W116