Selector Lever Inspection - Mazda 2002 6 Workshop Manual

18. Press the interlock cable lock piece in until it is
locked.
Caution
• Applying a load to the interlock cable
while pressing the lock piece in can
affect the lock unit operation.
19. Remove the snap pin from the lock unit hole A, B
and C.
20. Connect the brake switch connector with the
brake pedal released.
Caution
• The clearance between the brake switch
and the brake pedal is automatically
adjusted to the correct amount when the
brake switch connector is connected
after the brake switch has been properly
installed. If the brake switch is not
properly installed or the connector is
connected before installation, the
clearance may be incorrect, causing a brake light malfunction. Therefore, always verify that the
brake switch is properly installed before connecting the connector.
• Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again.
Therefore, replace the switch with a new one when replacing the power brake unit or the pedal, or
performing any procedure that changes the pedal stroke.
21. Inspect shift lock operation. (See
End Of Sie

SELECTOR LEVER INSPECTION

1. Turn the ignition switch to ON (engine OFF).
2. With the brake pedal depressed, verify that there is a "click" at each range when shifted.
3. Verify that the selector lever can be shifted.
4. Verify that there is a "click" at each position when
shifted from P position to L range.
5. Verify that the positions of the selector lever and
the indicator are aligned.
• If not as specified, adjust the TR switch.(See
K–18 TRANSAXLE RANGE (TR) SWITCH
ADJUSTMENT.)
6. Verify that the vehicle operates in each selected
range.
End Of Sie
K–46–2
AUTOMATIC TRANSAXLE SHIFT MECHANISM
K–45 SHIFT-LOCK
INTERLOCK CABLE
UNLOCK
LOCK UNIT
A B
SLIDER PIN
INSPECTION.)
LOCK PIECE
LOCK
A6E5616W012
INTERLOCK
CABLE
C
BRAKE SWITCH
CHU0514W012
A6E561646102W01
A6E5616W002