Mazda 2002 6 Workshop Manual page 276

Hide thumbs Also See for 2002 6:
Table of Contents

Advertisement

STEP
3
VERIFY RELATED PENDING OR STORED
DTCS
• Turn ignition key to OFF, then ON (Engine
OFF).
• Verify pending code or stored DTCs using
WDS or equivalent.
• Is other DTC present?
4
INSPECT IAC VALVE MALFUNCTION
• Perform IAC valve inspection.
(See
F–13 IDLE AIR CONTROL (IAC) VALVE
INSPECTION.)
• Is IAC valve okay?
5
INSPECT A/C MAGNET CLUTCH OPERATION
• Turn blower motor switch off.
• Is magnet clutch still on?
6
INSPECT PURGE SOLENOID VALVE
MALFUNCTION
• Perform purge solenoid valve inspection.
(See
F–39 PURGE SOLENOID VALVE
INSPECTION.)
• Is purge solenoid valve okay?
7
INSPECT AIR CLEANER ELEMENT
• Remove air cleaner element with engine
running.
• Is engine speed increased?
8
INSPECT THROTTLE BODY PASSAGE
• Is throttle body clogged?
9
INSPECT ENGINE COMPRESSION
• Inspect engine compression.
(See
B–9 COMPRESSION
• Is engine compression okay?
10
INSPECT GENERATOR
• Perform generator inspection.
(See
G–7 GENERATOR
• Is generator okay?
11
VERIFY TROUBLESHOOTING OF DTC P0506
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Start engine.
• Clear DTC from PCM memory using WDS or
equivalent.
• Depress brake pedal for 14 s or more.
• Is PENDING CODE the same as DTC
present?
12
VERIFY AFTER REPAIR PROCEDURE
• Perform "After Repair Procedure".
(See
F–66 AFTER REPAIR
• Is there any DTC present?
End Of Sie
F–146
ON-BOARD DIAGNOSTIC
INSPECTION
INSPECTION.)
INSPECTION.)
PROCEDURE.)
Yes Repair applicable DTCs.
(See
F–67 DTC
TABLE.)
No
Go to next step.
Yes Go to next step.
No
Replace IAC valve, then go to Step 11.
Yes Refer to "A/C is always on or A/C compressor runs
continuously." of ENGINE SYMPTOM
TROUBLESHOOTING, then go to Step 11.
(See
F–181 ENGINE SYMPTOM
No
Go to next step.
Yes Go to next step.
No
Replace purge solenoid valve, then go to Step 11.
Yes Replace air cleaner element, then go to Step 11.
No
Go to next step.
Yes Clean or replace throttle body passage, then go to Step 11.
No
Go to next step.
Yes Go to next step.
No
Overhaul engine, then go to Step 11.
Yes Go to next step.
No
Repair or replace related part, then go to next step.
Yes Replace PCM, then go to next step.
(See
F–43 PCM
REMOVAL/INSTALLATION.)
No
Go to next step.
Yes Go to applicable DTC troubleshooting.
(See
F–67 DTC
TABLE.)
No
Troubleshooting completed.
ACTION
TROUBLESHOOTING.)

Advertisement

Table of Contents
loading

Table of Contents