Mazda 2002 6 Workshop Manual page 404

6 Selector cable
7 Shift cable
8 Selector cable bracket
9 Clutch release cylinder
10 Starter
11 Endplate cover
12 Transaxle mounting bolt (upper side)
Tie-rod end ball joint
13
(See N–11 Tie-rod End Ball Joint Removal
14 Stabilizer control link
15 Damper fork
Lower arm (front, rear) ball joint
(See R–19 Front Lower Arm (Rear) Ball Joint
16 Removal Note)
(See R–16 Front Lower Arm (Front) Ball Joint
Removal Note)
Drive shaft
17 (See M–17 DRIVE SHAFT REMOVAL/
INSTALLATION.)
No.1 Engine Mount Bracket Removal Note
1. Support the engine using the SST before
removing the No.1 engine mount.
2. Remove the No.1 engine mount.
Manual Transaxle Removal Note
1. Loosen the SST (49 E017 5A0)and lean the engine toward the transaxle.
2. Support the transaxle on a jack.
3. Remove the transaxle mounting bolts.
4. Remove the transaxle.
MANUAL TRANSAXLE
Joint shaft
18
INSTALLATION.)
No.1 engine mount
(See
19 Note)
(See
Mount Bracket Installation
20 Crossmember bracket
Crossmember component
Note)
21 (See
INSTALLATION)
No.4 engine mount
22 (See
Mount Bracket Installation
23 Transaxle mounting bolt (lower side)
Manual transaxle
24 (See
(See
(See M–12 JOINT SHAFT REMOVAL/
J–7 No.1 Engine Mount Bracket Removal
J–8 No.1 Engine Mount and No.4 Engine
Note)
R–23 FRONT CROSSMEMBER REMOVAL/
J–8 No.1 Engine Mount and No.4 Engine
Note)
J–7 Manual Transaxle Removal
J–8 Manual Transaxle Installation
J
Note)
Note)
A6E5614W049
A6E5112W003
J–7