Mazda 2002 6 Workshop Manual page 1034

Hide thumbs Also See for 2002 6:

Table of Contents

6. Control the SST (Deployment tool) to the SST

(Adapter harness).

7. Connect the red clip of the SST (Deployment tool)

to the positive battery terminal and the black clip

to the negative battery terminal.

8. Verify that the red light on the SST (Deployment

tool) is illuminated.

9. Make sure all persons are standing at least 6 m

{20 ft} from the vehicle.

10. Press the activation switch on the SST

(Deployment tool) to deploy the side air bag

Curtain air bag module

1. Remove the curtain air bag module. (See

2. Secure the curtain air bag module in a vise, and

cut off the deployment section, as shown in the

• Be sure not to collapse the pipe on the

side where it is cut. If it is collapsed, the

interior pressure of the pipe will build up

and can cause it to explode during air

bag module deployment.

3. Connect the SST (Adapter harness) to the curtain

air bag module as shown in the figure. (5HB)

AIR BAG SYSTEM

T–122 CURTAIN AIR BAG MODULE

REMOVAL/INSTALLATION.)

Chapters

Table of Contents