License Plate Light Removal/Installation; Combination Switch Removal/Installation - Mazda 2002 6 Workshop Manual

High-mount brake light removal note
1. Tie a string to the end of the connector of the
high-mount brake light beforehand so that the
connector can be passed easily through the rear
spoiler during installation.
5HB
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See
3. Remove in the order indicated in the table.
1 Connector
2 Nut
3 High-mount brake light
4 Lens
5 Socket
6 High-mount brake light bulb
4. Install in the reverse order of removal.
End Of Sie

LICENSE PLATE LIGHT REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the rear finisher. (See
3. Remove in the order indicated in the table.
1 Connector
2 License plate light
3 Lens
4 License plate light bulb
4. Install in the reverse order of removal.
End Of Sie

COMBINATION SWITCH REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See
INSTALLATION.)
3. Remove the steering wheel. (See
4. Remove the column cover. (See
5. Remove the clock spring. (without DSC) (See
Caution
• For vehicles with DSC, the clock spring is generally not to be removed from the combination
switch as may result in a malfunction of the steering angle sensor. However, remove it only when
replacing the clock spring as a single unit by referring to CLOCK SPRING REMOVAL/
INSTALLATION. (See
EXTERIOR LIGHTING SYSTEM
S–95 LIFTGATE LOWER TRIM
S–54 REAR FINISHER
T–120 DRIVER-SIDE AIR BAG MODULE REMOVAL/
N–7 STEERING WHEEL AND COLUMN
S–84 COLUMN COVER
T–125 CLOCK SPRING
T–125 CLOCK SPRING REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION)
REMOVAL/INSTALLATION)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION)
REMOVAL/INSTALLATION.)
A6E8112W116
A6E8112W142
T
A6E811251270W01
A6E8112W108
A6E811266120W01
T–37