Sunroof Switch Removal/Installation; Sunroof Switch Inspection - Mazda 2002 6 Workshop Manual

Terminal Signal
1F Slide open
Sunroof relay
1G
ground
1H Tilt up
Slide close/
2A
tilt up
Slide open/tilt
2B
down
End Of Sie

SUNROOF SWITCH REMOVAL/INSTALLATION

Note
• The sunroof switch is together with the map light.
1. Disconnect the negative battery cable.
2. Remove the map light from the headliner.
3. Install in the reverse order of removal.
End Of Sie

SUNROOF SWITCH INSPECTION

1. Remove the sunroof switch.
2. Inspect for continuity between the sunroof switch terminals using an ohmmeter.
• If not as specified, replace the sunroof switch.
End Of Sie
SLIDING SUNROOF
Connected to Test condition
Sunroof is fully opening.
Sunroof switch
Other
Under any condition: inspect
GND
for continuity to ground.
Sunroof is tilting up. (Including
position when fully closed)
Sunroof switch
Other
Sunroof is opening/tilting
down.
Sunroof is closing/tilting up.
Sunroof motor
Other
Sunroof is opening/tilting
down.
Sunroof is closing/tilting up.
Sunroof motor
Other
A6E7740W022
Voltage (V)/
Action
Continuity
• Inspect sunroof switch
0
(See S–81 SUNROOF
SWITCH INSPECTION)
B+
• Inspect related harness
• Inspect related harness
Yes
• Inspect sunroof switch
0
(See S–81 SUNROOF
SWITCH INSPECTION)
B+
• Inspect related harness
• Inspect sunroof switch
0
(See S–81 SUNROOF
SWITCH INSPECTION)
B+
• Inspect sunroof motor
(See S–79 SUNROOF
0
MOTOR INSPECTION)
• Inspect related harness
• Inspect sunroof switch
B+
(See S–81 SUNROOF
SWITCH INSPECTION)
0
• Inspect sunroof motor
(See S–79 SUNROOF
0
MOTOR INSPECTION)
• Inspect related harness
A6E774066560W01
S
A6E774066560W02
A6E7740W023
S–81