Mazda 2002 6 Workshop Manual page 1024

2. Connect the SST (Adapter harness) to the driver-
side air bag module as shown in the figure.
3. Install the driver-side air bag module. (See
DRIVER-SIDE AIR BAG MODULE REMOVAL/
INSTALLATION.)
4. Connect the SSTs (Deployment tool) to the SSTs (Adapter harness).
49 H066 002
5. Connect both SSTs (Deployment tool) to the battery. Connect the power supply red clip to the positive battery
terminal, and the black clip to the negative battery terminal.
6. Verify that the red lamp on both SSTs (Deployment tool) is illuminated.
7. Make sure all persons are standing at least 6 m {20 ft} away from the vehicle.
8. Press the activation switch on the SST
(Deployment tool) connected with 49 L066 002 (a
yellow connector) of the SST (Adapter harness),
and after 3 s, press the activation switch on the
other SST (Deployment tool) to operate (deploy)
the air bag module (both inflators).
Warning
• Verify that air bag module operation
(explosive) sound occurs twice. If no
operation (explosive) sound was heard or
a single operation (explosive) sound was
heard, both inflators would not have
operated (deployed) properly. This may
cause serious injury because the air bag module may operate (deploy) accidentally. If the two
operation (explosive) sounds are not heard, perform Step 8 again. In case that the two operation
(explosive) sounds in total are not verified even though Step 8 is performed again, leave the air
bag module alone for 30 min or more before getting near it again.
• The air bag module is very hot immediately after it is operated (deployed). You can get burned. Do
not touch the air bag module for at least 15 min after deployment.
9. Disconnect the SST (Deployment tool) from the SST (Adapter harness).
Passenger-side air bag module
Warning
• The passenger-side air bag module is a dual inflator type. If one inflator is forced to operate
(deploy), the other may operate (deploy) accidentally. To prevent injury while disposing of the air
bag module, make sure to operate (deploy) both passenger-side air bag module inflators
simultaneously, following the procedure below.
Note
• The SSTs, two types of adapter harnesses (for inflators No.1 and No.2) and two deployment tools are to
be used to operate (deploy) the passenger-side air bag module.
T–128
AIR BAG SYSTEM
T–120
49 G066 003
49 L066 002
49 H066 002
49 H066 002
A6E8130W011
CHU0810W301
ACTIVATION
SWITCH
A6E8130W028