Front Scuff Plate Removal/Installation; Rear Scuff Plate Removal/Installation; C-Pillar Trim Removal/Installation - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

FRONT SCUFF PLATE REMOVAL/INSTALLATION

1. Pull the front scuff plate upward, then disengage

clips B, pins C, D and hooks E from the body, and

remove the front scuff plate.

2. Install in the reverse order of removal.

1. Pull the rear scuff plate upward, then disengage

clips A, pin B, and hooks C from the body, and

remove the rear scuff plate.

2. Install in the reverse order of removal.

1. Remove the tire house trim.

2. Turn the seaming welt over.

3. Remove the cap using a fastener remover, and

remove the bolt (with curtain air bag system).

4. Disengage clips A and clip B using a fastener

5. Pull the C-pillar trim forward, then disengage

hook C from the body, and remove the C-pillar

6. Install in the reverse order of removal.

1. Remove the tire house trim.

2. Remove the trunk side upper trim

3. Turn the seaming welt over.

4. Remove the cap using a fastener remover the

bolt. (with curtain air bag system)

5. Disengage clips A and pin B using a fastener

6. Pull the C-pillar trim forward, then disengage the

hook from the body.

7. Remove the rear center seat belt tongue from the

C-pillar trim. (LH only)

8. Remove the C-pillar trim.

9. Install in the reverse order of removal.

A6E774468710W01

A6E774468730W01

A6E774468240W01

Table of Contents