Mazda 2002 6 Workshop Manual page 587

Hide thumbs Also See for 2002 6:

Table of Contents

Mounting Rubber Assembly Note

1. Apply soapy water to the rubber part of the mounting rubber.

2. Press the mounting rubber until the mounting

rubber end comes out completely from the gear

housing using the SSTs and a press.

3. Reverse the gear housing, then press the

mounting rubber until the mounting rubber end

comes out completely from the other side. At this

time, mounting rubber end and steel pipe are

Oil Seal, Inner Guide Assembly Note

1. Install a new O-ring and a new seal ring to the rack's piston.

2. After installing the seal ring, seat it properly at the piston circumference.

3. Apply grease to a new oil seal and inner guide.

4. Install the oil seal to the SST.

ENGINE SPEED SENSING POWER STEERING

Chapters

Table of Contents