Clutch Switch Inspection; Neutral Switch Inspection - Mazda 2002 6 Workshop Manual

CLUTCH SWITCH INSPECTION

Note
• Perform the following inspection only when directed.
Continuity Inspection
1. Verify that the clutch switch is installed properly.
2. Disconnect the negative battery cable.
3. Remove the clutch switch.
4. Inspect for continuity between the clutch switch
terminals using an ohmmeter.
• If the clutch switch is okay, but CPP PID value
is out of specification, carry out of the "Clutch
Switch Circuit Open/Short Inspection".
• If not as specified, replace the clutch switch.
Specification
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See
REMOVAL/INSTALLATION.)
2. Inspect the following harness for open or short.
(Continuity check)
Open circuit
• Clutch switch terminal B (harness-side) and PCM
terminal 1R
• Clutch switch terminal D and body GND
Short circuit
• Clutch switch terminal B (harness-side) and
power supply
• Clutch switch terminal B (harness-side) and body
GND
End Of Sie

NEUTRAL SWITCH INSPECTION

Note
• Perform the following inspection only when directed.
Continuity Inspection
1. Disconnect the negative battery cable.
2. Remove the neutral switch.J–5 MANUAL TRANSAXLE
3. Inspect for continuity between the neutral switch
terminals using an ohmmeter.
• If the neutral switch is okay, but CPP/PNP PID
value is out of specification, carry out of the
"Circuit Open/Short Inspection".
• If not as specified, replace the neutral switch.
Specification
CONTROL SYSTEM
A6E3940W022
F–43 PCM
REMOVAL/INSTALLATION.)
A6E3940W025
A6E394018660W01
F
A6E3940W020
A6E3940W021
A6E394017640W01
A6E3940W023
F–59