Mazda 2002 6 Workshop Manual page 466

DTC No.
P0762 Shift solenoid C stuck ON
P0763 Shift solenoid C malfunction (electrical)
P0766 Shift solenoid D stuck OFF
P0767 Shift solenoid D stuck ON
P0768 Shift solenoid D malfunction (electrical)
P0771 Shift solenoid E stuck OFF
P0772 Shift solenoid E stuck ON
P0773 Shift solenoid E malfunction (electrical)
P0841 Oil pressure switch circuit malfunction
P0850 Neutral switch input malfunction
P1410 Variable air duct valve circuit malfunction
P1562 PCM +BB voltage low
P2006 VTCS stuck close
P2009 VTCS circuit low input
P2010 VTCS circuit high input
P2228 BARO sensor circuit low input
P2229 BARO sensor circuit high input
P2502 Generator output voltage signal no electricity
P2503 Battery overcharge
P2504 Generator terminal B circuit open
U0073 CAN bus off
PCM cannot receive any signals from ABS,
U0121
ABS/TCS or DSC HU/CM
PCM cannot receive any signals from
U0155
combination meter
End Of Sie
DTC P0500
DTC P0500 Vehicle speed sensor (VSS) circuit malfunction
• Vehicle speed signal not input after following conditions are met and 4.5 seconds or more have passed
— D, L, or S range.
— Engine coolant temperature 60 °C {140 °F} or above.
— Turbine speed 1,500 rpm or above.
Diagnostic support note:
• This is a continuous monitor (CCM).
DETECTION
• MIL illuminates if PCM detects the above malfunction condition in two consecutive drive cycles or in one
CONDITION
drive cycle while the DTC for the same malfunction has been stored in the PCM.
• PENDING CODE is available if PCM detects the above malfunction condition during first drive cycle.
• FREEZE FRAME DATA is available.
• HOLD indicator light flashes.
• DTC is stored in the PCM memory.
• VSS malfunction
• Open circuit between VSS terminal B and PCM terminal 3C
• Short to ground between VSS terminal B and PCM terminal 3C
POSSIBLE
• Open circuit between VSS terminal A and fuse block connector (X-01) terminal AJ
CAUSE
• Open circuit between VSS terminal C and body ground
• Damaged connectors between VSS and PCM
• PCM malfunction
ON-BOARD DIAGNOSTIC
Condition
HOLD
indicator Monitor
MIL DC
light item
flashes
ON YES 2 CCM
ON YES 1 CCM
ON YES 2 CCM
ON YES 2 CCM
ON YES 1 CCM
ON YES 2 CCM
ON YES 2 CCM
ON YES 1 CCM
OFF NO 2 CCM
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
(See F–67 DTC TABLE)
Memory
Page
function
(See K–95 DTC
×
P0762)
(See K–96 DTC
×
P0763)
(See K–99 DTC
×
P0766)
(See K–100
×
DTC P0767)
(See K–102
×
DTC P0768)
(See K–104
×
DTC P0771)
(See K–105
×
DTC P0772)
(See K–107
×
DTC P0773)
(See K–109
×
DTC P0841)
A6E567001030W05
K–55
K