Oil Seal (Differential) Replacement; Vehicle Speedometer Sensor Removal/Installation - Mazda 2002 6 Workshop Manual

OIL SEAL (DIFFERENTIAL) REPLACEMENT

1. On level ground, jack up the vehicle and support it evenly on safety stands.
2. Drain the oil from the transaxle.
3. Remove the front wheels and splash shields.
4. Separate the drive shaft and joint shaft from the transaxle. (See
INSTALLATION.) (See
5. Remove the oil seals using a screwdriver.
6. Using the SST and a hammer, tap each new oil
seal in evenly until the SST contacts the transaxle
case.
7. Coat the lip of each oil seal with transaxle oil.
8. Insert the drive shaft and joint shaft to the
transaxle. (See M–17 DRIVE SHAFT REMOVAL/
INSTALLATION.) (See
REMOVAL/INSTALLATION.)
9. Install the wheels and splash shields.
10. Add the specified amount and type of oil. (See
3 TRANSAXLE OIL
End Of Sie

VEHICLE SPEEDOMETER SENSOR REMOVAL/INSTALLATION

Without ABS
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner compornent. (See
4. Disconnect the vehicle speedometer sensor connector.
5. Remove the vehicle speedometer sensor.
6. Apply transmission oil to a new O-ring and install it on a vehicle speedometer sensor.
7. Install the vehicle speedometer sensor.
Tightening torque
7.8—11.3 N·m
{80—115 kgf·cm, 57.6—83.3 in·lbf}
8. Connect the vehicle speedometer sensor connector.
9. Install the air cleaner compornent. (See
10. Install the battery and battery tray.
11. Connect the negative battery cable.
End Of Sie
J–4
MANUAL TRANSAXLE
M–12 JOINT SHAFT
M–12 JOINT SHAFT
REPLACEMENT.)
F–10 INTAKE-AIR SYSTEM
F–10 INTAKE-AIR SYSTEM
M–17 DRIVE SHAFT REMOVAL/
REMOVAL/INSTALLATION.)
J–
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
A6E511219240W01
A6E5112W009
A6E5112W001
A6E511217400W01