Mazda 2002 6 Workshop Manual page 919

POWER SYSTEM, EXTERIOR LIGHTING SYSTEM
Type C
1. Remove the relay.
2. Inspect for continuity between the relay terminals
using an ohmmeter.
• If not as specified, replace the relay.
End Of Sie
DISCHARGE HEADLIGHT SERVICE WARNINGS
Discharge headlight bulb service warnings
• To prevent electrical shock when replacing the discharge headlight bulb, dry hands thoroughly, and
carry out work in an area out of rain.
• When the light switch is on, approx. 25,000 V
of high voltage passes through the discharge
headlight bulb socket. Because of the danger
of electrical shock, do not insert fingers or a
circuit tester.
• When the headlights are on, high voltage
flows around the socket and bulb. When
turning on the discharge headlights while
working, always leave the headlights in the
vehicle-installed condition to prevent
electrical shock.
Discharge headlight control unit service warnings
• Because of the danger of electrical shock,
when inspecting with a circuit tester or similar
device, do not inspect the discharge headlight
control unit as a single unit or disassemble it.
• If there are scratches or damage to the
discharge headlight control unit, or it has
been impacted, there may be damage despite
apparent normal operation. Therefore, to
prevent electrical shock or operation error,
replace with new parts.
End Of Sie
A6E8110W126
EXTERIOR LIGHTING SYSTEM
A6E8110W122
A6E811251060W01
T
A6E8112W163
A6E8112W164
T–25