Center Panel Module Removal/Installation - Mazda 2002 6 Workshop Manual

CENTER PANEL MODULE REMOVAL/INSTALLATION

1. Cancel the anti-theft operation. (with anti-theft system) (See
2. Disconnect the negative battery cable.
3. Remove the glove compartment.
4. Remove the rear console.
5. Remove in the order indicated in the table.
1 Dial (manual A/C only)
2 Screw (manual A/C only)
3 Screw
4 Bolt
5 Center panel module
(See T–96 Center Panel Module Removal
6 Connector
7 Antenna feeder
6. Install in the reverse order of removal.
Caution
• Make certain that the wiring harness and
antenna feeder are not caught between
the unit and dashboard. If the harness or
the antenna feeder is caught between the
unit and dashboard, it may cause trouble
or malfunctions.
7. Operate the anti-theft system by setting the code number. (with anti-theft system) (See
SYSTEM.)
Center Panel Module Removal Note
1. Pull the center panel module toward you, then
disengage clip A from the dashboard, and remove
the center panel module.
End Of Sie
T–96
AUDIO AND NAVIGATION SYSTEM
Note)
T–93 ANTI-THEFT SYSTEM.)
A6E812466900W02
A6E8124W020
T–93 ANTI-THEFT
A6E8124W029