Rear Wiper Motor - Mazda 2002 6 Workshop Manual

INTERMITTENT REAR WIPER RELAY REMOVAL/INSTALLATION
5HB
1. Disconnect the negative battery cable.
2. Remove the trunk side trim. (See
3. Remove in the order indicated in the table.
1 Connector
2 Bolt
3 Interittent rear wiper relay
4. Install in the reverse order of removal.
End Of Sie
INTERMITTENT REAR WIPER RELAY INSPECTION
1. Connect the connector to the intermittent rear wiper relay.
2. Connect the negative battery cable.
3. Measure the voltage at the intermittent rear wiper relay using voltmeter.
• When inspecting terminal D for continuity, disconnect the intermittent rear wiper relay connector.
4. If the value are not as specified in the Terminal Voltage List (Reference), inspect the parts under "Action" and
related wiring harnesses.
5. If the system does not work properly even though the parts or related wiring harnesses do not have any
malfunction, replace the intermittent rear wiper relay.
Terminal Voltage Table (Reference)
Terminal Signal
A Autostop
D GND
T–66
WIPER AND WASHER
S–92 TRUNK SIDE TRIM
Connected to
Rear wiper is operating (INT
position or ON position)

Rear wiper motor

Other
Under any condition: inspect for
GND
continuity to ground
REMOVAL/INSTALLATION)
Test condition
Voltage (V)/
Action
Continuity
• Inspect R. WIP 10 A
Alternates 0
and B+ fuse
• Inspect wiper and
washer switch (See
68 WIPER AND
WASHER SWITCH
INSPECTION)
B+
• Inspect rear wiper
motor (See
REAR WIPER MOTOR
INSPECTION)
• Inspect related harness
• Inspect GND
Yes
• Inspect related harness
A6E811666810W01
A6E8116W101
A6E811666810W02
A6E8116W134
T–
T–62