Fuel-Filler Lid And Opener; Fuel-Filler Lid And Opener Removal/Installation; Fuel-Filler Lid Adjustment - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

1. To remove the fuel-filler lid opener, remove the left side trunk side trim (4SD) or trunk side lower trim (5HB).

2. To remove the fuel-filler lid opener cable, perform the following and turn over the floor covering.

(1) Remove the driver-side front seat.

(2) Remove the driver-side front scuff plate.

(3) Remove the driver-side rear scuff plate.

(4) Remove the driver-side B-pillar lower trim.

(5) Remove the driver-side tire house trim.

(6) Remove the rear seat cushion. (R.H.D., 4SD)

(7) Remove the rear seat installation bolts (front side), then lift the rear seat cushion. (R.H.D., 5HB)

3. Remove in the order indicated in the table.

Fuel-filler lid

Fuel-filler lid opener

Fuel-filler lid opener lever

Fuel-filler lid opener cable

4. Install in the reverse order of removal.

5. Adjust the fuel-filler lid. (See

ADJUSTMENT.)

1. If not as specified, loosen the fuel-filler lid installation bolts, and reposition the fuel-filler lid.

2. Measure the gap and height between the fuel-filler lid and the body.

a: 1.7—3.7 mm {0.067—0.145 in}

b: -0.5—1.5 mm {-0.019—0.059 in}

3. Tighten the bolts.

FUEL-FILLER LID AND OPENER

S–46 FUEL-FILLER

A6E772456890W01

A6E772442410W01

Table of Contents