Dynamic Stability Control; Dsc System Inspection - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

1. Verify that the battery is fully charged.

2. With ignition switch on, verify that the ABS warning light goes out after 2.4 seconds.

3. Turn the ignition switch off.

4. On level ground, jack up the vehicle and support it evenly on safety stands.

5. Shift the transaxle to N position.

6. Release the parking brake.

7. Rotate the wheels by hand, and inspect for brake drag.

Operation of DSC Inspection

1. Perform the "Preparation."

2. Connect WDS or equivalent to the DLC-2.

3. Set up an active command modes inspection

according to the combination of commands

• When working with two people, one should

press on the brake pedal, the other should

attempt to rotate the wheel being inspected.

Pressure retention

Command name

DYNAMIC STABILITY CONTROL

A6E692067650W01

Table of Contents