Front Suspension; Front Shock Absorber And Spring Removal/Installation - Mazda 2002 6 Workshop Manual

FRONT SHOCK ABSORBER AND SPRING REMOVAL/INSTALLATION

Caution
• Performing the following procedures without first removing the ABS wheel-speed sensor may
possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the
following procedures, remove the ABS wheel-sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
.
1 Bolt (ABS wheel-speed sensor)
2 Bolt (brake hose bracket)
3 Nut (front stabilizer control link)
4 Bolt (front shock absorber lower side)
(See R–10 Bolt (Front Shock Absorber Lower Side)
Removal Note)
5 Dynamic damper
6 Damper fork
(See R–12 Damper Fork Installation
7 Nut (front shock absorber upper side)

FRONT SUSPENSION

FRONT SUSPENSION
8
9
10
11
12
Note) 13
14
Front shock absorber and coil spring
(See R–11 Front Shock Absorber and Coil Spring
Installation Note)
Piston rod nut
(See R–10 Piston Rod Nut Removal
Mounting rubber
Bound stopper
Dust boot
Coil spring
(See R–10 Coil Spring Installation
Front shock absorber
A6E741404910W01
R
A6E7414W017
Note)
Note)
R–9