Clutch Fluid; Clutch Fluid Inspection; Clutch Fluid Replacement - Mazda 2002 6 Workshop Manual

Hide thumbs Also See for 2002 6:

Table of Contents

• A common reservoir is used for the clutch and brake system fluid.

• The fluid in the reservoir must be maintained between the MIN/MAX level during replacement.

• Be careful not to spill clutch fluid on a painted surface. If this should happen, wash it off

immediately.

• Do not mix different brands of clutch fluid.

• Do not reuse the clutch fluid that was drained out.

1. Remove the under cover.

2. Draw the fluid from the reservoir with a suction pump.

3. Remove the bleeder cap from the clutch release cylinder and attach a vinyl hose to the bleeder plug.

4. Place the other end of the vinyl hose into a container.

5. Slowly pump the clutch pedal several times.

6. With the clutch pedal depressed, loosen the bleeder screw using the SST to let fluid escape.

7. Tighten the bleeder screw using the SST to stop

8. Repeat Steps 4 and 5 until only clean fluid is

9. Tighten the bleeder screw.

Tightening torque

5.9—8.8 N·m {60—90 kgf·cm, 53—78 in·lbf}

10. Add fluid to the MAX mark.

11. Install the under cover.

12. Verify the correct clutch operation.

CLUTCH FLUID

A6E491216010W01

A6E491216010W02

Table of Contents