Mazda 2002 6 Workshop Manual page 438

5 TR switch connector
6 Transaxle connector
7 VSS connector
8 Oil dipstick and filler tube
9 Harness bracket
10 Oil hose
11 Selector cable
12 Transaxle mounting bolt (upper side)
13 Starter
14 Endplate cover
15 Tie-rod end ball joint
(See N–11 Tie-rod End Ball Joint Removal
16 Stabilizer control link
17 Damper fork
18 Lower arm (front, rear) ball joint
(See R–19 Front Lower Arm (Rear) Ball Joint
Removal Note)
(See R–16 Front Lower Arm (Front) Ball Joint
Removal Note)
19 Drive shaft
(See M–17 DRIVE SHAFT REMOVAL/
INSTALLATION)
No.1 Engine Mount Bracket Removal Note
1. Support the engine using the SST before removing the No.1 engine mount.
2. Remove the No.1 engine mount.
Transaxle Removal Note
1. Loosen the part marked A and lean the engine
toward the transaxle.
2. Support the transaxle on a jack.
3. Remove the transaxle mounting bolts.
AUTOMATIC TRANSAXLE
20
21
22
23
24
Note)
25
26
27
28
Drive shaft
(See M–17 DRIVE SHAFT REMOVAL/
INSTALLATION)
Joint shaft
(See M–12 JOINT SHAFT REMOVAL/
INSTALLATION)
No.1 engine mount
(See K–31 No.1 Engine Mount Bracket Removal
Note)
(See K–33 No.1 Engine Mount and No.4 Engine
Mount Bracket Installation Note)
Crossmember bracket
Crossmember (See R–23 FRONT
CROSSMEMBER REMOVAL/INSTALLATION.)
Torque converter installation nuts (See
Converter Nuts Removal Note)(SeeK–33 Torque
Converter Nuts Installation Note)
No.4 engine mount
(See K–33 No.1 Engine Mount and No.4 Engine
Mount Bracket Installation Note)
Transaxle mounting bolt (lower side)
Transaxle (See K–31 Transaxle Removal Note)(K–
32 Transaxle Installation Note)
K–32 Torque
K
A6E5614W049
A6E5614W050
K–31