Mazda 2002 6 Workshop Manual page 454

AUTOMATIC TRANSAXLE SHIFT MECHANISM
8. Push the snap pin (or a φ1.5 round bar or
INTERLOCK CABLE ADJUSTMENT
simular.) into hole A by fully pushing the slider pin
in.
9. Push the snap pin into hole B and hole C of the
lock unit until it passes through.
10. Disconnect the brake switch connector.
11. Remove the brake switch. (See
PEDAL REMOVAL/INSTALLATION.)
12. Install the new brake switch. (See
PEDAL REMOVAL/INSTALLATION.)
Caution
• Do not connect the brake switch
connector until the interlock cable
adjustment is completed.
13. Install the lock unit to the bracket. (See
14. Rotate the slider pin to release the lock, and verify that the it slides freely.
15. Verify that the slider pin contacts the brake pedal
stopper rubber and rotate the slider pin to lock.
16. Install the interlock cable end onto the interlock
link on the selector lever.
17. Fit the interlock cable in the U-groove in the
selector lever base plate and install the clip.
AUTOMATIC TRANSAXLE
K – 4 6
AUTOMATIC TRANSAXLE SHIFT MECHANISM
BHE051409000W03A
P–9 BRAKE
P–9 BRAKE
K–49 Interlock Cable Installation
LOCK UNIT
C
B
A
SLIDER PIN
Note.)
STOPPER
RUBBER
INTERLOCK
CABLE
BRAKE SWITCH
CHU0514W012
MARKING K
SLIDER PIN
MARKING
BHE0514W011
A6E5616W010
A6E5616W011
K–46–1