Mazda 2002 6 Workshop Manual page 957

REAR WIPER MOTOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the rear wiper arm and blade. (See
INSTALLATION.)
3. Remove the liftgate lower trim. (See
4. Remove in the order indicated in the table.
1 Connector
2 Outer bushing
3 Bolt
4 Rear wiper motor
5. Install in the reverse order of removal.
6. Adjust the rear wiper arm and blade. (See
REAR WIPER ARM AND BLADE
ADJUSTMENT.)
End Of Sie
REAR WIPER MOTOR INSPECTION
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See
3. Disconnect the rear wiper motor connector.
4. Connect battery positive voltage to the rear wiper motor terminal A and the ground to a bare metal part of the
vehicle and the rear wiper motor terminal B.
5. Verify that the rear wiper motor operates.
6. Disconnect the ground to the terminal B while the
rear wiper is operating.
T–62
WIPER AND WASHER
T–63 REAR WIPER ARM AND BLADE REMOVAL/
S–95 LIFTGATE LOWER TRIM
T–64
S–95 LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
REMOVAL/INSTALLATION)
A6E811667450W01
A6E8116W110
A6E811667450W02
A6E8116W119
A6E8116W132