Mazda 2002 6 Workshop Manual page 978

STEP INSPECTION
2 Remove key from steering lock (Key
reminder switch off.)
End Of Sie
PID/DATA MONITOR AND RECORD PROCEDURE
1. Connect SST (WDS or equivalent) to the vehicle
DLC-2 16-pin connector.
2. Access and monitor PIDs using SST (WDS or
equivalent).
Monitor Item Table
• The PID/DATA monitoring items for the instrument cluster is as shown in the table below.
PID item
CCNT_HE Continuous codes
ECT_GAUGE Temperature gauge
FUEL Fuel flow
ODOMETR Total distance
SPEEDSG Speedometer
RPM Tachometer
End Of Sie
FUEL GAUGE SENDER UNIT INSPECTION
1. Move the float to the topmost and bottommost
positions, and verify that the resistance between
terminals A and B of the unit and the position of
the float are as indicated in the figure.
• If they are not as indicated, replace the fuel
gauge sender unit.
End Of Sie
WARNING AND INDICATOR SYSTEM
INDICATION
Definition
ACTION
Measure voltage at instrument cluster terminal 2B.
Is voltage 0 V?
• If as specified, replace instrument cluster.
• If not as specified, inspect following parts.
— Key reminder switch
— Wiring harness (Key reminder switch—
instrument cluster)
Input signal to instrument cluster is okay.
DLC-2
Unit/Condition
Number of continuous codes
°C °F
l/min
km mile
km/h mile/h
rpm
A6E811855430W07
A6E3970W002
T
—: Not applicable
Terminal
—
2W, 2X
2M
2W, 2X
A6E811860960W01
A6E8118W002
T–83