Joint Shaft Disassembly/Assembly - Mazda 2002 6 Workshop Manual

Clip Installation Note
1. Install a new clip onto the joint shaft with the opening facing upward. Ensure that the diameter of the clip does
not exceed the specification on installation.
2. After installation, measure the outer diameter. If it
exceeds the specification, repeat Step 1 using a
new clip.
Outer diameter specification
31.2 mm {1.23 in} max.
End Of Sie

JOINT SHAFT DISASSEMBLY/ASSEMBLY

1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
1 Joint shaft
(See M–14 Joint Shaft Disassembly
(See M–16 Joint Shaft Assembly
2 Bearing
(See M–15 Bearing Disassembly
(See M–15 Bearing Assembly
Joint Shaft Disassembly Note
1. Disassemble the joint shaft.
M–14
DRIVE SHAFT
Note)
Note)
Note)
Note)
3 Dust seal (Left)
(See M–16 Dust Seal (Left) Assembly
4 Dust seal (Right)
(See M–15 Dust Seal (Right) Assembly
5 Bracket
A6E0313W021
A6E631625700W03
A6E0313W026
Note)
Note)
A6E0313W052