Mazda 2002 6 Workshop Manual page 952

R.H.D.
1. Disconnect the windshield wiper motor connector.
2. Connect battery positive voltage to terminal B or
A and ground to terminal D, and inspect the
operation of the windshield wiper motor as
indicated below.
Terminal
B
A
3. Disconnect battery positive voltage from terminal
B of the motor while the wipers are operating.
4. Verify that the wipers do not stop in the park
position.
5. Short between the motor terminals E and A and
connect battery positive voltage to the motor terminal C.
6. Verify that the wipers operate at low speed again, then stop in the park position.
• If not as specified, replace the windshield wiper motor.
End Of Sie
WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
1 Cap
2 Nut
3 Windshield wiper arm (See
Arm Installation Note)
4 Windshield wiper blade
5 Rubber brush
2. Install in the reverse order of removal.
3. Adjust the windshield wiper arm and blade. (See
T–58 WINDSHIELD WIPER ARM AND BLADE
ADJUSTMENT.)
Windshield Wiper Arm Installation Note
1. Clean the windshield wiper arm connector shafts
using a wire brush before installing the windshield
wiper arms.
End Of Sie
WIPER AND WASHER
Operation
High
Low
T–57 Windshield Wiper
A6E8116W128
A6E811667320W01
T
A6E8116W111
A6E8116W103
T–57