Mazda 2002 6 Workshop Manual page 60

Hide thumbs Also See for 2002 6:

Table of Contents

2. Install the M6 x 1.0 bolt in by hand.

3. Turn the crankshaft clockwise the crankshaft is in

the No.1 cylinder TDC position.

4. Hold the crankshaft pully by using the SST.

5. Tighten the crankshaft pulley lock bolt using the

following two steps.

(1) Tighten to 96—104 N·m {9.8—10.6 kgf·m,

70.9—76.7 ft·lbf}

(2) Tighten 87°—93°

6. Remove the M6 x 1.0 bolt.

7. Remove the SST from the camshaft.

8. Remove the SST from the cylinder block lower

9. Rotate the crankshaft clockwise two turns until

the TDC position.

• If not aligned, loosen the crankshaft pulley

lock bolt and repeat from Step 1.

10. Install the cylinder block lower blind plug.

Tightening torque:

18—22 N·m {1.9—2.2 kgf·m, 13.3—16.2 ft·lbf}

Cylinder Head Cover Installation Note

1. Apply silicone sealant to the mating faces as

• Install the cylinder head cover within 10

minutes of applying the silicone sealant.

Dot diameter:

4.0—6.0 mm {0.16—0.23 in}

2. Install the cylinder head cover with a new gasket.

TIMING CHAIN

Chapters

Table of Contents