Mazda 2002 6 Workshop Manual page 1025

Hide thumbs Also See for 2002 6:

Table of Contents

1. Remove the glove compartment.

2. Disconnect the passenger-side sir bag module connector.

3. Connect the SST (Adapter harness) to the

passenger-side air bag module as shown it the

4. Connect the SST (Deployment tool) to the SST (Adapter harness).

5. Connect both SSTs (Deployment tool) to the battery. Connect the power supply red clip to the positive battery

terminal, and the black clip to the negative battery terminal.

6. Verify that the red lamp on both SSTs (Deployment tool) is illuminated.

7. Make sure all persons are standing at least 6 m {20 ft} away from the vehicle.

8. Press the activation switch on the SST

(Deployment tool) connected with 49 L066 002 (a

yellow connector) of the SST (Adapter harness),

and after 3 s, press the activation switch on the

other SST (Deployment tool) to operate (deploy)

the air bag module (both inflators).

• Verify that air bag module operation

(explosive) sound occurs twice. If no

operation (explosive) sound was heard or

a single operation (explosive) sound was

heard, both inflators would not have

operated (deployed) properly. This may

cause serious injury because the air bag module may operate (deploy) accidentally. If the two

operation (explosive) sounds are not heard, perform Step 8 again. In case that the two operation

(explosive) sounds in total are not verified even though Step 8 is performed again, leave the air

bag module alone for 30 min or more before getting near it again.

• The air bag module is very hot immediately after it is operated (deployed). You can be burned. Do

not touch the air bag module for at least 15 min after deployment.

9. Disconnect the SST (Deployment tool) from the SST (Adapter harness).

AIR BAG SYSTEM

Chapters

Table of Contents