Removing And Installing Oil Pressure Switch F1; Removing And Installing Oil Temperature Sender G8 - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
8-cylinder TDI engine (4.2 ltr. 4-valve common rail), mechanics - Edition 12.2013
1.13 Removing and installing oil pressure
switch - F1-
Removing
– Carefully pull engine cover panel off four retaining pins one
after the other -arrows-.
– Pull off bonnet seal at lock carrier.
– Unplug electrical connector -2- at oil temperature sender -
G8- .
– Unplug electrical connector -1- at oil pressure switch - F1- .
– Unscrew oil pressure switch - F1- .
Installing
Installation is carried out in the reverse order; note the following:
Note
Renew seal.
Tightening torque
Component
Oil pressure switch - F1- to oil line
1.14 Removing and installing oil temperature
sender - G8-
Removing
– Carefully pull engine cover panel off four retaining pins one
after the other -arrows-.
– Pull off bonnet seal at lock carrier.
210
Rep. gr.17 - Lubrication
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Nm
20